Eclipse - Fujitsu Ten Car Stereo System E-iSERV User Manual

0

Out of 0 Ratings

Owner's of the Eclipse - Fujitsu Ten Car Stereo System E-iSERV gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 119
 
74
Various Settings
Displaying measurement results
and save to USB memory
Align the microphone with the actual
ear position and attach it to the
headrest or other appropriate fixture.
(Attach the microphone using tape or
string.) Connect the USB memory if
data is to be saved.
After pressing the button, a 10-second
countdown begins. Leave the vehicle
during that time.
After ten seconds, pink noise will be
output from the speakers and the
measurement of the frequency
characteristics will start. The
“Measuring” message appears on the
display while measurement is in
progress.
When measurement is complete, the
measurement results will appear on
the display. You can adjust the volume
(by turning the [VOL] button) and
restart measurement while
measurement is in progress.
Press the button [6] once more to
cancel measurement.
The measurement result can be
referred to when adjusting parametric
equalizer.
ATTENTION
Do not play music from the USB while
measuring frequency characteristics.
Time alignment adjustment (Time
Alignment)
The delay time and level of the sound from each
speaker can be adjusted in order to correct any
phase mismatches in the sound resulting from
the listening position. (For details about speaker
layout selection, refer to page 77.)
The time alignment setting mode is
activated.
Each time the button is pressed, the
band changes in the following order.
4-speaker layout:
FL → FR → RL → RR → SW →
FL → www
3-way speaker layout:
HL → HR → ML → MR → LL → LR →
HL → www
The delay time can be adjusted within
0.0 to 10.0 ms (0.1 ms for the main
unit).
Right:
Increases the time.
Left:
Decreases the time.
1
Connect the RCA connector of the
optional microphone (MEI-100) to
the L-CH of the AUX jack of the
main unit.
2
Press button [6] on the PEQ screen
for less than one second.
1
Press the [SELECT] (Up/Down)
button to select Time Align.
2
Press the [ENTER] button.
3
Press the [ENTER] button to select
the speaker band to be adjusted.
4
Press the [SELECT] (Right/Left)
button to adjust the time delay in
the arrival of the sound.

   Find Your Products By Category