Eclipse - Fujitsu Ten Car Stereo System E-iSERV User Manual

0

Out of 0 Ratings

Owner's of the Eclipse - Fujitsu Ten Car Stereo System E-iSERV gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 119
 
ESN security operating procedure
61
X
"CANCEL" will be displayed and the
CD will be ejected. ESN is now
deactivated.
ATTENTION
If a CD other than the Key CD is inserted, the
registration cannot be cancelled. In this case,
the “ERR” message is displayed for two
seconds, and the CD playback mode is
activated.
The front panel closes.
How to change the Key CD
Refer to "How to cancel the Key CD".
Refer to "How to program the Key
CD".
How to resume normal operation
(ESN security lock out)
If power is disconnected while ESN security is
active (a Key CD was programmed),
operation is disabled until power is restored
and the main unit unlocked. Follow this
procedure to resume normal operation.
"OK" will be displayed for two seconds
and the CD will begin playing.
ATTENTION
• If the incorrect CD is inserted, an “ERR_”
(“ERR” and error number) message will
appear for two seconds, after which the CD
will be ejected.
• If “ERR5” (the 5th time an error has
occurred) appears on the display, the
[HELP] message will appear, and the CD
will be ejected. If the “HELP” message
appears, perform the ESN security lock out
operation by following the procedure in
"What happens if an incorrect CD is
inserted?" on page 61.
• You must be use the same CD used for Key
CD programming; a duplicate CD may not
work properly.
What happens if an incorrect CD is
inserted?
"HELP" will be displayed for 5
seconds. Then the serial number will
be displayed.
"SEC" will be displayed for two
seconds. Then the six digit rolling code
will be displayed.
4
Insert the Key CD into the disc slot.
5
Press the [ e (OPEN/EJECT)]
button.
1
First, cancel the existing Key CD.
2
Next, program a new Key CD.
1
When the power is turned on after
the battery power has been
disconnected, the “SEC” message
is displayed for two seconds. The
message then changes to the
“DISC” message. Press the [e
(OPEN/EJECT)] button.
2
Insert the Key CD into the disc slot.
1
After the 5th incorrect attempt, the
“HELP” message will be displayed
for five seconds.
2
Press the [e (OPEN/EJECT)]
button
to close the front panel.
3
While pressing button [6], press
the [SCREEN/TEXT] button, and
hold both for five seconds.

   Find Your Products By Category