0
Owner's of the Eclipse - Fujitsu Ten Car Stereo System E-iSERV gave it a score of 0 out of 5. Here's how the scores stacked up:
How to operate the Sound Adjustment Mode
73
XII
The preset value is overwritten by the
value set using the above steps.
The time alignment and crossover
adjustments will also be stored at this
time.
Selecting an equalizer mode
from memory
Press a preset button to select the equalizer
mode set in memory on the button. The buttons
that set equalizer modes in the memory are
called preset buttons.
The preset pattern stored in the
memory will be retrieved.
ATTENTION
When the preset value is changed, the display
shows as follows:
Measuring/displaying frequency
characteristics
Frequency characteristics inside the vehicle can
be measured and shown on the display. The
measurement result can be referred to when
adjusting the parametric equalizer. This result is
also necessary to automatically correct the
parametric equalizer setting using E-iSERV
Audio Customize.
ATTENTION
• Adjust time alignment (refer to page 74) and
crossover (refer to page 75) before
measuring frequency characteristics.
• When measuring frequency characteristics,
CSII and Loudness settings are
automatically cancelled.
• Close all doors and windows while
measurement is in progress.
8
Press a button from [1] to [5] for
more than two seconds to preset a
setting value.
1
Select a button from [1] to [5] and
press it for less than one second
while the PEQ setting mode is
activated.
P
1 to 5 (Preset ch No.)
CAUTION
1
2
In order to make the measurement of
frequency characteristics easier, slight
errors may occur in the measurement data
under some circumstances when this
function is used. In addition, it is not
equivalent to the precise measurements
that can be made by specialist measuring
devices.
Find Your Products By Category
Please Login
