0

Out of 0 Ratings

Owner's of the ADC Clothes Dryer Gas Electric Steam gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 66
 
13
SECTION IV
PROGRAM SELECTION
NOTE: Programs are stored in the Phase 5 coin microprocessor controller (computer) memory and
are cataloged as Program Locations (PL).
TEMPERATURE DISPLAY MODE
By closing the Program Switch (PS) located on the back side of the Phase 5 coin microprocessor controller
(computer), the light emitting diode (L.E.D.) display will read the temperature in the dryer in either Fahrenheit
(°F) or Celsius (°C), depending on how the temperature conversion status is in PL01. The temperature display
mode can be activated while the dryer is in the operating cycle, or off. While in the operating cycle, the circuit
indicators are visible for troubleshooting purposes.
NOTE: The dryer cannot be started while the Phase 5 coin microprocessor controller (computer)
Program Switch (PS) is closed, unless the cycle was already in progress.
RIGHT COIN COUNT (rCC)/LEFT COIN COUNT (LCC)
The “HI TEMP” key lets the operator review the coin counters. If the operator presses the “HI TEMP” key,
the computer displays “_LCC.” The operator could then press either the “PERM PRESS” key to view the
“Left Coin Count” or the “HI TEMP” key and the computer would display “_rCC.” Again, the operator could
press the “PERM PRESS” key to view the “Right Coin Count.” While displaying the coin count, if the operator
presses the “HI TEMP” key the computer then displays “CxCC” (x = “r” or “L”) to indicate “clearing” the coin
count. The operator then presses the “PERM PRESS” key to clear the coin count or the “HI TEMP” or “LO
TEMP” key to exit without clearing the coin count.