0
Owner's of the ADC Clothes Dryer AD-115ES gave it a score of 0 out of 5. Here's how the scores stacked up:
32 American Dryer Corp. 113202-10
K. PREOPERATIONAL TEST
ALL dryers are thoroughly tested and inspected before leaving the factory. However, a preoperational test
should be performed before the dryer is publicly used. It is possible that adjustments have changed in transit or
due to marginal location (installation) conditions.
1. Turn on electric power to the dryer.
2. Make sure the main door is closed and the lint drawer is securely in place.
3. Refer to the Operating Instructions for starting your particular model dryer.
4. Check to ensure that the basket (tumbler) starts in the clockwise (CW) direction. Additionally, check the
direction of the blower motor impellor (fan) to ensure that the blower motor impellor (fan) rotates in the
clockwise (CW) direction as viewed from the front. If it is, the phasing is correct. If the phasing is
incorrect, reverse two (2) of the leads at L1, L2, or L3 of the power supply connections made to the dryer.
IMPORTANT: The dryer blower motor/pulley that drives the impellor/fan (squirrel cage) when
viewed from the back of the dryer must turn in the counterclockwise (CCW)
direction, otherwise the dryer efficiency
will be drastically reduced and premature
component failure can result.
5. Heat Circuit Operational Test
a. Gas Models
1) When the dryer is first started (during initial start-up), the burner has a tendency not to ignite on the
first attempt. This is because the gas supply piping is filled with air, so it may take a few minutes for
this air to be purged from the lines.
2) The dryer is equipped with a Direct Spark Ignition (DSI) system, which has internal diagnostics. If
ignition
is not established after three (3) attempts, the heat circuit DSI module will LOCKOUT until
it is manually reset. To reset the DSI system, open and close the main door and restart the dryer
(press the “START” key).
NOTE: During the purging period, check to be sure that ALL gas shutoff valves are open.
3) Once ignition is established, a gas pressure test should be taken at the gas valve pressure tap of
each dryer to ensure that the water column (W.C.) pressure is correct and consistent.
NOTE: Water column pressure requirements (measured at the gas valve pressure tap):
Natural Gas ---------------------3.5 Inches (8.7 mb) Water Column.
Liquid Propane (L.P.) Gas --- 10.5 Inches (26.1 mb) Water Column.
IMPORTANT: There is no regulator provided in an L.P. dryer. The water column (W.C.) pressure
must be regulated at the source, (L.P. tank) or an external regulator must be added
to each dryer.
Find Your Products By Category
Please Login
