5.0
Owner's of the 3D Connexion Sewing Machine 7318 gave it a score of 5.0 out of 5. Here's how the scores stacked up:
22
q
w
e
r
t
z
xcv b
q
w
e
r
t
y
ui
n
4-Step Buttonhole
Machine setting
q Stitch pattern:
w Stitch width: 4–5
e Stitch length: 0.5–1
r Thread tension: 1 – 5
t Presser foot: Sliding buttonhole foot J
z Set the pattern selector dial at “ ”.
Carefully mark buttonhole length on fabric.
Place the fabric under the foot with the
buttonhole marking running toward you.
Draw both of needle and bobbin thread to the
left. Move the slider toward you so that the top
mark w on the slider meets the start mark q.
q Start mark
w Top mark
e Needle thread
r Bobbin thread
NOTE:
The scale on the slider is engraved in
centimeters.
x Sew forward until you reach the front marking
of your buttonhole. Stop sewing at a left stitch.
c Raise the needle to its highest position.
Set the pattern selector dial at “ ”. Sew 5
stitches, then stop sewing at a right stitch.
v Raise the needle to its highest position.
Set the pattern selector dial at “ ”. Sew until
the needle reach the back marking of button
hole.
b Raise the needle to its highest position.
Set the pattern selector dial at “ ”.
Sew 5 stitches, then stop sewing. Set the stitch
length dial to “0” and the pattern selector dial at
straight sewing.
Sew a few locking stitches.
n Raise the needle and presser foot. Remove the
fabric from the machine and cut the sewing
thread. Insert a pin inside the bartack.
Then cut the opening with a seam ripper.
Take care not to cut the stitches.
t Needle thread
y Bobbin thread
To adjust buttonhole stitch density:
Set the stitch length dial between “ ” to
adjust the buttonhole stitch density.
u Denser buttonhole
i Coarser buttonhole
Find Your Products By Category
Please Login
