5.0
Owner's of the 3D Connexion Sewing Machine 7318 gave it a score of 5.0 out of 5. Here's how the scores stacked up:
21
w
e
r
t
q
w
e
q
y
Button Sewing
Machine setting
q Stitch pattern: C
w Stitch width: Adjust as necessary
e Stitch length: Any
r Thread tension: 3 – 7
t Presser foot: Zigzag foot A
y Feed dog: Lowered
Unthread the needle. Adjust the stitch width to
match it with the span of the holes in the button.
Turn the handwheel to check if the needle enters
into each hole in the button.
Lower the foot to hold the button in place.
The holes in the button should align with the slot
of the foot.
A pin can be placed on the foot to form a shank.
Make sure to check if the needle enters into both
holes in the button.
q Pin
Re-thread the needle and sew about 10 stitches
and cut the needle and bobbin threads at the
beginning.
Raise the presser foot and remove the fabric. Cut
the needle and bobbin threads leaving 8˝ (20 cm)
tails.
Bring the needle thread between the button and
fabric through the holes in the button.
Pull the needle thread to pick bobbin thread up to
the right side of the fabric.
Wind the threads to from a shank and tie them
together.
w Needle thread
e Bobbin thread
NOTE:
Raise the feed dog after sewing.
Find Your Products By Category
Please Login
