0

Out of 0 Ratings

Owner's of the 321 Studios Coffeemaker INDUCTION HOBS gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 28
 
11
3) Th
e left display shows alternatively a [ C ] and a [ 0 ]
4) Press the key lock until both displays indicate either [ C ] or [ - ].
5) Take your fingers away from the keys and press again the [ - ] key during a few
seconds until some [ E ] appear.
6) You will hear a "beep" sound and the [ E ] will blink.
7) The [ E ] are automatically transformed into [ C ] → The configuration has been
canceled.
VI) How to configure the hob ?
1) Use a suitable induction pot with a minimum diametre size of 16cm.
2) Select the heating zone by pushing the corresponding [ + ] key.
3) Put the pot on the corresponding heating zone.
4) Wait until [ C ] converts to [ - ]. The zone is configured
5) Use the same procedure for each other heating zone which displays [ C ]
6) The configuration is made if all zones are detected and if nothing is displayed
Use only 1 pot to configure the hob.
Never put two or more pots on the heating zones during the configuration.
If [ E 4 ] display persists call the After-sales Service
The hob or the cooking zone doesn’t start-up
The
hob is badly connected on the electrical network.
The protection fuse cut-off
The locking function is activated
The sensitive keys are covered of grease or water.
An object is put on a key.
The symbol [ U ] displays
Ther
e is no pan on the cooking zone.
The pan is not compatible with induction.
The bottom diameter of the pan is too small.
The symbol [ C ] or [ E ] displays
Ca
l
l the After-sales Service.
One or all cooking zones cut-off
The
safety system functioned
You forgot to cut-off the cooking zone for a long time.
One or more sensitive keys are covered.
The pan is empty and its bottom overheated.
The hob also has an automatic reduction of power level and breaking Automatic
overheating
Continuous ventilation after cutting-off the hob
Thi
s is not a failure, the fan continuous to protect the electronic device.
The fan cooling stops automatically.