321 Studios Coffeemaker INDUCTION HOBS User Manual

0

Out of 0 Ratings

Owner's of the 321 Studios Coffeemaker INDUCTION HOBS gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 28
 
23
WHAT TO D
O IN CASE OF A PROBLEM
The sy
mbol [ E 4 ] displays :
The h
ob must be configured according to the following procedure.
I) Warning : before starting all pots must be removed from the cooktop.
II) Disconnect the cooktop from the main supply : remove fuse or disconnect circuit
breaker.
III) Connect the cooktop to the main supply : replace the fuse or connect the circuit
breaker.
IV) Procedure : You must provide yourself with a ferromagnetic bottom container 16 cm
minimum diametre.
* start within 2 minutes after the connection to the main supply
* do not use the [ O/I ] key.
V) How to cancel the existing configuration :
1) Push on the locking key and keep your finger on the key
2) With a finger from the other hand activate successively and quickly a - b - c
(7322240) or d - e - f (7321240) keys. Start from left to right. A double "beep"
sound will inform you of a bad manipulation and you will have to restart from
point 1.
3) The left display shows alternatively a [ C ] and a [ 0 ]
4) Press the key lock until both displays indicate either [ C ] or [ - ].
5) Take your fingers away from the keys and press again the [ - ] key during a few
seconds until some [ E ] appear.
6) You will hear a "beep" sound and the [ E ] will blink.
7) The [ E ] are automatically transformed into [ C ] → The configuration has been
canceled.
VI) How to configure the hob ?
1) Use a suitable induction pot with a minimum diametre size of 16cm.
2) Select the heating zone by pushing the corresponding [ + ] key.
3) Put the pot on the corresponding heating zone.
4) Wait until [ C ] converts to [ - ]. The zone is configured
5) Use the same procedure for each other heating zone which displays [ C ]
6) The configuration is made if all zones are detected and if nothing is displayed
Use only 1 pot to configure the hob.
Never put two or more pots on the heating zones during the configuration.
If [ E 4 ] display persists call the After-sales Service
The hob or the cooking zone doesn’t start-up
Th
e h
ob is badly connected on the electrical network.
The protection fuse cut-off
The locking function is activated
The sensitive keys are covered of grease or water.
An object is put on a key.
a
b
c
d
e
f

   Find Your Products By Category