0

Out of 0 Ratings

Owner's of the Cisco Systems Network Card 32369 gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 52
 
next-server
Cisco IOS DHCP Server 39
next-server
To configure the next server in a Dynamic Host Configuration Protocol (DHCP) client’s boot
process, use the next-server DHCP pool configuration command. Use the no form of this command
to remove the boot server list.
next-server address [address2...address8]
no next-server address
Syntax Description
Defaults
If the next-server command is not used to configure a boot server list, the DHCP server uses
inbound interface helper addresses as boot servers.
Command Modes
DHCP pool configuration
Usage Guidelines
This command first appeared in Cisco IOS Release 12.0(1)T.
You can specify up to eight servers in the list. Servers are listed in order of preference (address1 is
the most preferred server, address2 is the next most preferred server, and so on).
Examples
The following example specifies 10.12.1.99 as the IP address of the next server in the boot process:
next-server 10.12.1.99
Related Commands
bootfile
ip dhcp pool
ip helper-address
option
address Specifies the IP address of the next server in the boot process, which is
typically a Trivial File Transfer Protocol (TFTP) server. One IP
address is required, although you can specify up to eight addresses in
one command line.