Airlink101 Security Camera AIC250 User Manual

0

Out of 0 Ratings

Owner's of the Airlink101 Security Camera AIC250 gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 71
 
5
2. Getting Started
Note: Before using the IP Camera, you’ll need to perform the following tasks:
1. Connect the IP Camera to your network.
2. Install the Setup Wizard.
3. Gather information about your local network address.
4. Configure the IP Camera using the Setup Wizard.
Please follow the steps in this Manual carefully to ensure proper setup of the IP Camera.
Caution: The IP Camera is designed for indoor use only. Direct exposure to sunlight
may cause permanent damage to the CMOS sensor. When operating in extremely
bright environment, an iris lens or sun visor is recommended to protect the IP Camera.
Step 1 Connect one end of a network cable to the IP Camera and connect the other
end to one of the LAN ports of the router or switch (See the diagram below).
Step 2 Power on the IP Camera by connecting one end of the supplied power adapter
to the power jack of the Camera and connecting the other end to an electrical outlet.
Step 3 Verify that all the lights on the Camera are lit. If not, verify that all the
connections are secure and try again.

   Find Your Products By Category