0
Owner's of the ACS Clothes Dryer ACS Clothes Dryer gave it a score of 0 out of 5. Here's how the scores stacked up:
15, 30, & 60 cfm Compact Dryers Chapter 4: Operation 30 of 51
4-3 Dryer Operation Procedures
Controller Operation
1. Turn the disconnect (if applicable) on the control panel to the ON position. Power is
applied to the voltage line fuses, line side of the control power switch.
2. Turn the control power switch to the ON position. Power is applied to the
temperature control, programmable relay and dew point controller. The valve will
move to the start position as follows:
a. The valve motor rotates until the cam switch makes 2 transitions.
b. If the cam switch does not make a transition within 10 seconds, a valve
motor fault is generated. “VALVE MTR” is displayed on the relay screen,
the alarm light is activated. The valve motor, heaters, and blower shut off.
To restart the dryer, cycle control power to deactivate the alarm light and
restart the valve motor sequence.
Note: The relay screen which contains the Alarm Display Messages is located
inside the controller enclosure. For a list of Alarm Display Messages,
see Page 32.
WARNING! Do not attempt to check the Alarms on the Controller located within the
unit enclosure unless you are a qualified electrician!
c. The valve will normally complete one full cycle (revolution).
If the drying process shuts down due to an alarm, the dryer has been setup to
have the following operational features:
• The bed in process at power-down will remain in process.
• The bed in regeneration at power-down will remain in regeneration.
• The regeneration timing cycle will restart from the beginning.
3. Once the control power is on and no fault conditions exist, start the dryer as follows:
a. The process/regen blower is started.
b. The process heater is turned on and controlled by the E5CN controller.
c. The regen heater is turned on and the regeneration timing sequence is
initiated. For default timing settings for regeneration, see the table below.
Model
Heating
Cooling
15 cfm
30 cfm
15
45
60 cfm
N/A
N/A
Note: In a humid environment, you may change the setting to 20/45 for better
dew point management.
Find Your Products By Category
Please Login
