Acoustic Research Headphones ART7 User Manual

0

Out of 0 Ratings

Owner's of the Acoustic Research Headphones ART7 gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 96
 
ART7
2
17. Always leave sufficient space around the product for ventilation. Do not place product in or on
a bed, rug, in a bookcase or cabinet that may prevent air flow through vent openings.
18. Do not place lighted candles, cigarettes, cigars, etc. on the product.
19. Care should be taken so that objects do not fall into the product.
20. The MAINS plug is used as the disconnect device and shall remain readily operable.
21. Where there is more than one connection supplying HAZARDOUS VOLTAGES or
HAZARDOUS ENERGY LEVELS to equipment, a prominent marking, located close to the
entry point provided for a SERVICE PERSON to gain access to the hazardous parts, shall be
provided to indicate which disconnect device or devices isolate the equipment completely and
which disconnect devices can be used to isolate each section of the equipment.
WARNING: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THIS
EQUIPMENT.
COMPLIANCE WITH FCC REGULATIONS: This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
A Class II APPARATUS shall be permanently marked with the words "DOUBLE INSULATION" or
"Double Insulated" and "When servicing use only identical replacement parts."
NOTE: This Class B digital apparatus complies with Canadian ICES-003.
This symbol indicates that this
product incorporates double
insulation between hazardous
mains voltage and user
accessible parts.

   Find Your Products By Category