0
Owner's of the 3D Connexion Gas Grill GE SECURITY gave it a score of 0 out of 5. Here's how the scores stacked up:
Concord 17
For example, if the current date is January 15, 2000, press 011500 + #.
4. Press
* + 00 + # to exit the programming menus.
Adjusting
System Sounds
and Touchpad
Brightness
Arming Your System Silently
Use the Silent Arming feature to arm your system without disturbing people throughout the
house with arming status beeps. There are two methods for implementing Silent Arming:
• Silent on Demand. (User presses
5 before arming.)
• Arming Always Silent (Silent Arming feature on).
Regardless of the method employed, when Silent Arming is in effect, no Exit beeps sound.
Silent Arming on Demand
Pressing 5 before arming silences arming status beeps from touchpads and interior sirens for
only the current arming period.
Note
If Quick Arm feature is on,
an access code is not
required. See “Quick Arm”
for more information.
To use Silent Arming on demand:
1. From any touchpad, press 5.
2. Within 4 seconds enter:
2 + CODE or 3 + CODE.
Arming Always Silent
Note
Arming Always Silent may
have been disabled by your
installer.
Turning this feature on in User Programming means that the status beeps that come from touch-
pads and interior speakers while arming will always be silent. You will not have to enter
5
before arming, as with Silent Arming on Demand.
To enable Silent Arming:
Note
Exit Delay is doubled when
you enable Silent Arming.
1. Enter the programming menus by pressing 9 + System or Partition Master CODE.
2. Press
041.
3. To turn Silent Arming:
on, press
2 + #. No system status beeps will sound while arming.
off, press
1 + #. System status beeps will sound from touchpad while arming.
4. Press
* + 00 + # to exit the programming menus.
Adjusting the Touchpad Beeps (Fixed Display Touchpad Only)
The frequency or pitch of chime and trouble beeps from each fixed display touchpad can be
adjusted individually to a more desirable or distinct tone.
Chime and trouble beep tones sound using the default frequency during, or within 15 seconds of
any button activity at that specific touchpad.
To change status tone pitch:
1. Press and hold * + 0 until you hear a steady tone, then release the buttons.
2. Press and hold
1 to lower the pitch or press and hold 2 to raise the pitch.
3. Release the button when the desired pitch is heard.
After about 15 seconds of no touchpad activity, the steady tone stops sounding.
Adjusting the System Status Voice Volume
If you have an optional voice module installed, you may want to adjust the volume at which sys-
tem status messages are announced.
To change the voice volume:
1. Enter the programming menus by pressing 9 + System or Partition Master CODE.
2. Press
043.
3. Select a volume level
1 – 7 (7 being the loudest) and press #
4. Press * + 00 + # to exit the programming menus.
Find Your Products By Category
Please Login
